MG ENGINE. Suit TB TC, TD, TF, Y, W4/44. Complete long motor, loosely assembled to allow your inspection and configuration. XPAW block with GM-type split rear crank seal conversion installed. Crank requires machining to suit. New + 0.030" pistons and rings. 1280 cc. Test run only. TF/XPAW 24005 con-rods with cap-screw little end bolts. TD sump. TF oil pump and filter. TC and TD/TF/W4/44 front engine mount plate. Distributor, water pump, thermostat housing, rocker cover and side-plate included. Graham Russell-modified XPAW head. New TF 34/36mm valves. TD rocker cover. TDII/TF (120/9 teeth) and TC (93/10 teeth) flywheel/ring gear. Inlet manifold, no studs. $US 6,000.00. Consider separate sale of head and short motor.
Additional XPAG 7227 block with main caps. Requires boring, one sleeve in place and could be taken to 72 mm for 1466 cc. Fasteners, camshaft and sundry parts included. Pistons to suit: 4 off +0.100" with rings and 24005 TF balanced rods. Additional XPAW head with 33/31 mm valves, springs and rocker set. Additional inlet manifold, no studs. Inspect and make your sensible offer. Shipping can be arranged.
Peter Finlay Sydney Australia +6129872 2923. peter(at)finlays.com.au 02/10
For Sale -- Smiths heater in good shape came out of a 1947 MGTC was working when was pulled, but sold as is Asking . . . your best offer!? +1-850-819-9215 or email Steve Cook at mgtc1013(at)yahoo.com Item located in Panama City Florida 1/10
Additional door locks to secure the opening levers at many MG types. price is 18,- euros plus shipping. plase send your request via mail to Klaus Harthof, Olpe, Germany klaus.harthof (at) t-online.de 10/09
MG T.C. ALFIN BRAKE DRUMS. US $ 1000.00 PER SET OF FOUR. DRUMS ARE CAST IN A356 ALUMINUM WITH A CLOSE GRAINED MEHANITE CAST IRON LINER AND 100% CNC MACHINED TO EXACT TOLERANCE.
THEY LOOK GOOD AND THEY WORK LIKE A CHARM. YOU CAN CORNER FASTER BECAUSE NOW YOU CAN STOP. EG NO BRAKE FADE. CALL ME 714 897 9511.
HAZLEHUST INC. POBOX 2996 SEAL BEACH CA PO740. RJHATSEA (at) AOL.COM 10/09
MG TC Transmission 1945-1949 offered Bell housing not cracked and in excellent condition. Has the cross shaft and clutch fork. The rear portion of the trans mount is solid and not cracked All of the gears are in excellent condition Front and rear bearings and seals should be replaced due to age of unit. Shift tower is not available Price is $1400 Please contact David Blackwell TC#6674 at MGBLACWELL(at)webtv.net or call: Home: 1-631-475-2889 Cell: 1-576-9345
XPAG crank, uncut, magnafluxed. Will clean up with a 20 thou cut. $800
TC early TD head. Magnafluxed. Includes new valves. $500
Contact Dave Blackwell, Patchogue, N.Y, USA
MGBLACKWELL(at)webtv.com or call 1-631-576-9345 9/08
Shorrock C75 supercharger for sale, excellent condition, complete with carb & top pulley to suit MG, Mini, Austin, etc. Offers. Located in England. Call Steve on +44 (0) 7855777721 or at steve.wright(at)rbs.com 2/08
 |
 |
|
| TF 1500 (1955) for sale (price $20,000) | 1939 MG TB Roadster (price $30,000) | |
Also selling Lucas Fog lamp and horn for TC Ramasauskas, Zilvinas, Lemont, IL, USA ramasauskas(at)sbcglobal.net 11/08
TRADE a TA for a TC: I have what I believe is TA1560 (EAE 250), 1936 or 37 with partial provenance. Engine is Morris MPJM2A. It had a complete mechanical rebuild 3 years ago, paint and body, interior sometime prior to that. Recently I had the speedo/tach rebuilt by Nisonger, new tires and battery, restored the pre-war headlights and tail light. I'd be willing to trade it for a TC in excellent shape, documented mechanical history and chrome wire wheels. Lets talk; Dale.hamilton(at)med.va.gov. Dale Hamilton
TA Spares Various new spares (e.g. 8:39,7:37 CWP, sidelight, conrods, brake cylinders, pistons, etc.) and secondhand parts (e.g. exhaust manifold, starter motor, rear wings v.g.c., original headlamp rims, glasses, dipping reflectors, etc.). Send for full list davejheath(at)yahoo.co.uk David Heath 4/2007
The kits consist of 6 chrome acorn nuts, 4 short 1BA studs, 2 long 1/4" bsf studs and 4 gaskets. All the parts required to rebuild the various models of Altette horns as used on TA TB TC. Cost $30 US includes air post to anywhere in the world. Contact John Hancock mg.john.brenda(at)actrix.co.nz 8/2003
Midge Mascot T Series Windshields w/ “TRIPLEX” Logo Clips, Springs, and Hardware Bits Originality Items like Masking Boards &Tools See On-line Catalog for Many More Parts
Doug Pelton, Proprietor, 3754 E Nance Circle, Mesa, AZ 85215, 602-690-4927 www.FromTheFrameUp.com
No lifter wear. Custom ground for each application. Complete kit, Camshaft 8620 steel, Lifters, Pushrods, & state of the art 2 piece valve springs > $1300.00. Len Fanelli 356 East Grassy Sprain Rd. Yonkers, N.Y. 10710-2308, phone +1 914 420 8699 Email laf48(at)aol.com 4/2008
As a new part from german manufacturing in limited amount offered. Made in Germany from modern steel, hardened and grinded this diff is the ideal optimization for a TC with 5-gear conversion. this new crown wheel and pinion can be mounted without any modification in the opriginal pumkin housing. (the original rear axle transmission ration at the is TC 8 : 41) Though the saving from the 5th gear is reduced somewhat, but the TC becomes more lively. All gear´s ratios are shorter herewith. The car speeds up better and has a much better hill climbing behaviour and the 5th gear brings a very high end speed at faily low revs. The revs in gear 5 at 63 miles (100 kmh) are 550 revs lower as in gear 4 with original crown wheel and Pinion. 8 set are still available, the price is 974,- Euro (= 1180,- USD)+ pp more technical infos here Manufacturer: Manfred Jäger => his TC contacts please via walter at walter(at)mg-tabc.org
Available in 4 or 6 plug configurations. Marked MG inside an octagon at one end, the other end has LODGE or KLG plug information. These are color cast in modern materials from restored originals in the same BAKELITE brown color. 4 plug = USD$40, 6 plug =USD$45 plus mailing cost from Colorado, USA.
Please contact Ben Cordsen at sculptart(at)aol.com
MG T SERIES PARTS AND SERVICES: January 2009
TA/TC front steering knuckle stub axle inserts with ¾”-16 tpi thread, $50.00 each side. Use MG TD/TF/MGA stub axle nuts.
TA/TC Stub axles supplied and installed in your steering knuckles @$175.00 each side. Insert threads are ¾”-16 tpi, use nuts from MG TD/TF/MGA.
TB/TC/early TD oil filter adapter for modern spin-on-$105.00
TF/late TD oil filter adapter for modern spin-on-$70.00
TA/TC tapered rear axles with key and nut ( you taper bore your hubs ) $175.00 each (available TC 6 spline or Morris Minor 10 spline).
TA/TC new rear hubs taper bored for the above axles -$230.00 each.
TA/TC new front hubs -$220.00 each.
TA/TC new rear wheel bearing securing 2" hex nuts with lip seals and keeper washers-$70.00 the set.
TA/TC Alfin brake drums- $1,200.00 a set of four.
TA/TC new high ration crown wheel and pinion gear set, 4.625 ratio-enquire.
TB/TC rear gearbox steel reinforcing plates, pre-drilled ready for installation. Some studs and spacers required. Repairs a broken rear TC gearbox aluminum plate. $40.00
TA/TC/MMM Dual Spare wheel adapter, ( uses original lock-nut )- $175.00
TD/TF wire wheel front hubs- $185.00 each
TD/TF wire wheel rear hubs-$230.00 each.
TD/TF new brake master cylinder - $200.00 .
XPAG/XPEG Light steel racing flywheel-$575.00 Suitable for TC or TD with 7 1/2” heavy duty diaphram clutch cover. Use original starter and applicable 7 ¼” ring gear.
MG T Series Art Prints, Set 4 prints, TA Tickford, TC, TD, TF, size 14” x 18” mat, $25.00
All prices are in US$ with shipping extra.
I have a limited number of MG colour art prints which I obtained from the original artist. The prints are black TA Tickford, green TC, black TD and red TF. The original artwork was done in the late sixties/early seventies by Will Davies, a Toronto Ontario artist who owns an MG TC. The prints were taken from these drawings. The prints are on high quality paper suitable for framing. Overall paper size is 11 3/4" x 16 1/4" with the art work size being 9 1/4" x 14 1/4". MG T Series Art Prints, Set 4 prints, TA Tickford, TC, TD, TF, size 14" x 18" mat, $25.00 All prices are in CDN$ with shipping extra. Bob Grunau 150 Pinewood Trail, Mississauga, Ontario, Canada, L5G-2L1, +1-905-274-4136 or email grunau.garage(at)sympatico.ca
This kit enables you to renew that tatty hand brake lever that you forgot to due 20 years ago. the installation is simple and allows you to install without removal from the car fits all T series (not TD/TF) and Prewar cars. High quality chrome on brass. Cost is 55.00 plus shipping NYS sales tax if in NY.
JoeCurto(at)aol.com, phone +1-718-762-7878 Ph. Do not send CC number over internet 9/2000
Dash Panel Lettering Kit
STARTER MIXTURE FOG PANEL SLOW OVERDRIVE (IF WANTED) PULL PULL LAMP SWITCH RUNNING
Application is done directly to the dash panel eliminating the need to
remove the panel to screen print the lettering. The lettering is printed on
a very thin, adhesive backed mylar with a matte clear over laminate that
is very easy to apply.
The lettering is also available in black for later TCs with copper colored dash panels. The lettering is not applied individually but rather as a complete section. For example STARTER PULL is done in one piece with the appearance of being die cut.
Cost per complete set as outlined above is $33.50 including postage. Add $5.00 for OVERDRIVE if wanted. Please note preference of black or white with your order.
Please send check or money order payable to Paul Pothier at 345 Pinewood Dr, Bay Village, OH 44140-1338 USA. phone 001-(440) 250-9797
paulpothier(at)att.net 2/2001
NEW LED 'D' LAMPS
Upgrade your TC Tail lights with modern LED light power! These are two function (Brake & Tail light + License plate) units that are simple to install in your existing 'D' lights. Instructions included. Reduced electrical load and much BRIGHTER, SAFER tail lights. BE SAFE - BE SEEN p/n ST51D12VPG Positive ground $ 85.00 ea Plus Shipping p/n ST51D12VNG Negative ground $ 85.00 ea Plus Shipping
3' x 5' MG flags for sale at -- check it out! order from Terry Sanders, Oakland, CA email TATerry (at) pacbell.net Payment via PayPal at TATerry (at) aol.com or check/MO
 |
Black Hard Rubber Color Restorer Now you can bring back the deep black color and luster your black hard rubber dashboard knobs and switches once enjoyed when they were young and perky by using Pensbury Manor's GREAT KNOBS! to reblacken the oxidized, faded and browned out color that time and exposure to the elements has caused! GREAT KNOBS! comes in 1 and 2 oz. bottles - enough to restore from 25-50 normal size knobs and switches. $12.00 resp. $23.00 + s&h
|
|
| Syd Saperstein, Pensbury Manor 22 Saratoga Lane Alamo, CA 94507, tcsyd(at)sbcglobal.net | ||
Top pulley for Shorrock Supercharger(C 75 ) any condition, MGTC compatabile.
Paul F. Luther Jr
docluth81(at)yahoo.com 6/2010
WANTED To suit J75 Marshall supercharger, aluminium castings (or patterns) for nose extension, carby manifold and head manifold to suit XPAG TC belt drive installation. Any bits or info greatly appreciated. Harry Pyle hdpyle(at)bigpond.net.au 5/2005
