Page 1 of 1

TC floorboards

Posted: Mon Jun 11, 2018 10:30 am
by antijam
The original floorboards of my TC have a steel angle section 1" x 1" x 13" long screwed on one flange to their rear extremity, the other flange being screwed to rear bulkhead where it meets the floor.
1-P1320042.JPG
I can find no reference to this part in any lists or manuals and I'm wondering if it was an original fitment or something added by a previous owner to reinforce the gap/joint between the floorboard and the bulkhead.

Can anyone confirm one way or the other? Thanks in anticipation

Re: TC floorboards

Posted: Mon Jun 11, 2018 1:59 pm
by Marv
My '48 did not have any steel angle strips on the floorboards>

Re: TC floorboards

Posted: Mon Jun 11, 2018 3:39 pm
by Clifford Jay Lockrow
All of the TCs I have worked on (many) all had the angle piece you are referring to. If the floorboards have been replaced thy could have been left off.

Re: TC floorboards

Posted: Tue Jun 12, 2018 4:15 am
by Tom Wilson
It is original

Re: TC floorboards

Posted: Wed Jun 13, 2018 6:25 am
by antijam
Thanks for the feedback guys - looks like I need a new angle. ;)